1)get all the remotes you want to program even the ones already programmed(you can program up to 4 remotes)
2)get inside car and close all doors
3)insert key into ignition lock
4)turn ignition on then off and remove the key from the ignition cylinder
in less than 20 sec
5)press and hold the unlock button
6)press the lock button 3 times then release both buttons (the doors should lock then unlock)
to program additional remotes repeat the steps 5 an 6 on the other remotes in the same time interval without opening any doors or turning on ignition
7)open the door or open ignition to finish the programming process
how to program another remote from a existing car alarm remote immobilizer
Take it to the dealer
You can set your alarm to your car using the remote control exclusively for cars.
the remote has been lost and a new remote has been purchased. i had to remove the fuse to get the alarm to stop. how can i reset the alarm? So i can program the new remote.
reprogram 98 ford expedition with viper 600 alarm
488P Is the remote to a Python car alarm, need to be more specific on the alarm you have.
Read the owners manual.
An alarm remote is a remote control for an alarm system. A remote alarm is an alarm that rings somewhere far away from whatever set off the alarm.
If you are the owner you should know that if I tell you how, everybody will be able to disconnect the alarm of a z3 and your car will be vulnerable. So use the remote with the white buton.
Try this site... http://www.cars101.com/subaru/keyless.html#alpine used it to program a remote for my 2005 Outback Wagon
A 1993 Honda Civic alarm has an available program mode. To enable program mode place the key in the on position and press lock on the remote control 3. Do this three times in five seconds. Once in program mode the alarm can be reset.
Take the remote to any DMW dealer. They have to match the VIN mumber to the remote code. There may be a small fee involved.