This is what we did on my buddy Toyota. Put the key in turn it to run 5 times with in 10 seconds. Push any button on the remote. Your car will lock and unlock, if you have more than 1 remote do the same steps, and after you push any button on the 1st remote push any button on the second remote with in 5 seconds, again your car will lock and unlock.
I found this for 1998 Avalon... but it did not work for my 1997 Avalon XLS. The above did not work either.
1. Start with key out of the ignition, drivers door is open all others closed and
drivers door is unlocked.
2. Insert key into ignition (Do not turn) and pull it out.
3. Perform these steps within 40 seconds.
A. Using the power door lock switch on drivers door perform 5 lock/unlock cycles starting
with lock. Use an even pace and try to go about one cycle per second.
(1 cycle = 1 lock and 1 unlock.)
B. Close, then open drivers door.
4. Perform these steps within 40 seconds.
A. Using the power door lock switch on drivers door perform 5 lock/unlock cycles starting
with lock. Use an even pace and try to go about one cycle per second.
(1 cycle = 1 lock and 1 unlock.)
B. Insert the key in the ignition cylinder.
C. Turn the ignition to ON (Do NOT Start) then back to OFF.
D. Turn the ignition to ON (Do NOT Start) then back to OFF.
E. Remove the key from the ignition.
5. Within 3 seconds the power door locks should cycle automatically indicating successful entry
into programming mode. Return to step 1 if the locks do not cycle at this point.
6. Perform these steps within 40 seconds.
A. Press the lock and unlock buttons on the remote simultaneously for 1 second.
B. Immediately after letting go of the lock and unlock buttons,
Press the lock button by itself and hold for 2 seconds. Within 3 seconds the door locks
should cycle once indicating successful programming. If the door locks don't cycle or
cycle twice, repeat steps A and B, your remote has not been accepted.
C. Repeat steps A and B in step 6 for each new transmitter.
7. Close drivers door.
You should have programming instruction in the user manual.
A keyless entry remote on a 2001 Toyota Sequoia can not be reprogrammed at home. The key must be taken to a dealership where the engineers can program it with new settings.
take it to the dealership
how do you program keyless entry remote 98 GMC
How do you program the keyless entry on a 2005 Ford E350 Van?
How do you program a keyless entry remote for a 2005 KIA Amanti? Kent
This has to be done at the Toyota dealer ... they have the machine and the necessary software, both of which are considered proprietary, and generally not for sale to any entity except the dealers.
How to program a keyless entry remote for 2008 Pontiac g5
Keyless entry remotes must be programmed by a Hyundai dealer.
To program the 2004 Concorde spare keyless entry, you can take the vehicle to the dealer or you can download the manual. In the manual, there are steps to reset the keyless entry using your vehicle's VIN and other identifications.
You can get info on how to program any remote for vehciles at programyourremote.com all info needed was there and made it easy.
In order to program a VW Gold 2002 keyless entry, you would need the metal key flip, keyless entry remote and the immobilizer chip. Once you program the three components, you would have to program the immobilizer chip separately.?æ