You need the dealers scan tool.
only a dealership will be able to do this the key has a ohm rating in the chip that the car key solenoids corresponds with you would have to take it to the dealer if its a new key so they can program the chip in the key
yes but if the key has a chip in it then you will have to go to a dealership for tehm to program you a new one.
Yes, the owners manual details how to program your ignition to a new key.
you have to have acura dealer re program the new key. sucks but i guess its for your protection. you will need registration and i.d.
You can not bypass the system. It requires the dealers scan tool to program the key.
No, a 1991 Chrysler New Yorker does not have chip key.
If you have an original key you can do it very easily with that. Buy a new key with the chip in it and get it cut (usually only about 2-3 bucks) Place the existing key in the ignition and turn it to full power up, without starting it for 2 or 3 seconds. Turn it off and then place the new key in and do the same thing but let it sit that way for 3-4 minutes. This should program the new chip without having to pay the 30-100 for the dealer to do. The new key with a chip will run about 30 at the dealer, but if you look on eBay for blank "chip" keys, you can find them for 10-15 dollars. Good luck! I actually got this info from a service tech at Chevy who was a friend of mine. I tried it, and it worked.
The dealers scan tool is required.
how to program a new key 2008 mitsubishi colt
if your key had a chip in it, write down your vin#????????, and take your title insurance card, the dealer should be able to cut you a knew set of keys.
== ==
You can just contact your local jeep dealership and they can get you a new one and program it for you. I belive that the actual remote is usually around $30 and it doesnt take that long to program so the labor shouldn't cost to much depending on the hourly rate.