With the driver door closed, hold down the power unlock button on the door
panel.
Turn the ignition switch to the ON position.
Turn the ignition switch to the OFF position.
Turn the ignition switch to the ON position.
Turn the ignition switch to the OFF position.
Release the power unlock button on the door panel. The remote control door
lock receiver will respond in the following manner in order to indicate that
the receiver is in the programming mode:
Locking the doors
Unlocking the doors
Important
All extra transmitters must be programmed at this time. When a new
transmitter is programmed, the old transmitters will be deactivated.
Hold down the lock and unlock buttons on the transmitter until the remote
control door lock receiver will respond in the following manner:
Locking the doors.
Unlocking the doors.
Repeat step 7 for each additional transmitter.
Turn the ignition switch to the ON position in order to exit the transmitter
programming mode.
In order to reprogram the remote control door lock transmitter with a scan
tool, refer to Scan Tool instructions.
Memory Seat Recall Programming
Adjust the driver seat to the desired position.
Press the switch labeled SET. A chime confirmation will be heard.
Press the desired position switch labeled 1 or 2. Within 5 seconds from
pressing the SET switch, a chime confirmation will be heard.
Press the UNLOCK button on the desired transmitter (key fob) within 5
seconds from pressing the SET switch. A chime confirmation will be heard.
The transmitter (key fob) is now programmed with the desired position
switch. Pressing the transmitter UNLOCK button will cause a recall request
to be initiated and the seat will adjust to position 1 or 2.
The stored memory positions may be changed without having to reprogram the
transmitter.
The transmitter feature is available in all ignition positions.
Memory Seat Recall Unprogramming
Press the switch labeled SET. A chime confirmation will be heard.
Press the UNLOCK button on the transmitter (key fob) within 5 seconds from
pressing the SET switch.
Do not press any memory switch or power adjustment for 5 seconds. Pressing a
switch will cancel the unprogramming event and the transmitter will remain
programmed.
The transmitter (key fob) is now unprogrammed and pressing the UNLOCK button
will not effect memory seat operation.
No chime confirmation will be heard when the UNLOCK button is pressed if the
transmitter is unprogrammed.
I feel your pain.
Bought a 2005 Uplander from our elderly Aunt and immediately had an issue with the remote following a vehicle battery replacement. I looked everywhere, read multiple articles and found the dealer NEEDS to program match the remote to the vehicle. I would suggest getting 1 extra remote and having them programmed together, you can usually get a better deal for 2 of them at the same time. Shop around, the dealers all seem to charge a different price for this work.
GL Dean,
replaced battery and now remote doesnt work . how do you reprogram remote
how do you program your keyless remote for 2003 Chevy blazer
How do i you program keyless remote for a 2004 malibu?
How program my keyless entry remotes for 2003 chevy malibu
I have a use remote that I need to program
This vehicle requires a scan tool to program the remote, a dealer or locksmith will have to do it.
Try this site www.programyourremote.com
programyourremote.com simply put.. "Program Your Remote.com"
Check out this site www.programyourremote.com .....
see also 2004 silverado
Look in your owners manual for the directions.
go to the site programyourremote.com