Call the dealership or Go to you local library and get the repair book, its free to use or a few cents to copy.
You have to take it to a Mazda Dealership or locksmith.
You need one of these: http://en.wikipedia.org/wiki/Amstrad_CPC_664
How do I re-program a remote for a 1997 mazda millinea?
mazda premacy
yes. your local Mazda dealer can program them for you. if they say it cant be done; theyre lieing to get you to pay for another key fob. the systems are the same the key fob may "look" different.
No, the only features on the 2006 Mazda 3 Keyless Entry Remote is Lock, Unlock, and Panic.
You have to push the brake while you push the start button.
This is how to program a Mazda protege keyless (also works with other Mazda models) remote system: 1. Open Drivers door and leave open. 2. Lock and unlock the drivers door using the power lock switch on door panel. (not sure if this is required) 3. Insert key into the ignition. 4. Turn key to the ON and OFF position 3 times in 10 seconds. Leave key in ignition. ( i have seen others say 24 seconds for 4 & 5 combined) 5. Open and close drivers door 3 times ending with door in the open position. (you can depress the door switch instead) 6. Door locks should respond by locking and unlocking. 7. Press any button on remote 2 times. Doors should lock and unlock. 8. If programming a second remote press any button 2 times on it and door locks should cycle again. 9. Remove key from ignition and door locks will cycle again. 10. Test remotes. This information was received from: How do you program a keyless entry remote for your Mazda 5
I found instructions the following site. I have not tried it yet though...http://www.mpvclub.com/diy.php?id=43
Disconnect the positive cable then turn your key 3-4 times then reconnect the positive cable and start the car. You may have to reset your windows after that so you will put the windows down when you put them up hold the the button till you hear it click.
CR1620
Using the drivers side switch, cycle the power door locks LOCK, UNLOCK, LOCK, UNLOCK. Cycle the ignition from OFF to RUN eight times within 10 seconds, ending in the run position. The power door locks should cycle to indicate program mode, vehicle is ready to accept remotes. Press any button on the remote, once again the locks will cycle to indicate a successful program. Turn the ignition off to exit the program mode.