Generic gate controls have an array of numbered switches that can be set in a certain pattern (e.g., 1 up, 2 down, 3 up, 4 up, 5 up, 6 down) to program them.
The typical steps to follow when programming a generic gate control are:
1. Open an already programmed gate control by removing the screws
2. Open the unprogrammed gate control by removing the screws
3. Compare the switches inside both gate controls
4. Set the switches in the unprogrammed gate control to match those in the programmed gate control
5. Cover both gate controls and fasten their screws
a generic input device
nand gate
1. Explain NOR gate as Universal Gate A NOR gate is a simple OR gate with an inverter (NOT gate) at the output. NOR gates are considered Universal Gates because thay can be configured in a few different ways. Connecting the inputs on a NOR gate will result in a NOT gate (inverter). Connecting the above to the output of a NOR gate results in an OR gate.
What does gate means
universal logic gate is a gate using which you can make all the logic gates there are two such gates NOR gate and NAND gate
You can Use Remote gate And Sensor gate LivFuture Gate Automation Company
I have a 2005 Cheverolet ColBalt with 2 remotes, one works and one does not, how do i program it for both to work?
I was told to go to the dealer.
purchase and program new key remotes
How program my keyless entry remotes for 2003 chevy malibu
Mostly at the dealer for the factory remotes
You might not be able to program your 2002 Ford Explorer remotes because you might not have turned the ignition to off and then run eight times. You must do this to reset the remote.
how do you program your remote
There are many different types of television remotes. They have manufacturers remotes that you can purchase per whatever type of television you have. They also offer many different universal remotes which come with codes to program it to work with many different brands of television, DVD player and VCRs.
You can purchase new remotes online but a dealer or locksmith will need to program it.
There should a programming guide in the users manual
Check you owners manual, it will tell you how to reprogram them.