I have a 2005 Cheverolet ColBalt with 2 remotes, one works and one does not, how do i program it for both to work?
go to the dealer and have them do it , and don't forget to pay
way is my crank sensor over heating on my 2005 colbalt
Transmission fluid.
O'Grady - 2004 Remotes 1-13 was released on: USA: 13 May 2005
air is not blowing out of my 2005 cheverolet avalanche ducts but only when I am driving.
The bolt pattern is 5x110. Unless it's an LS/LT1 the bolt pattern is 4x100
To program a remote control for a 2005 Ford F-150, first, sit in the vehicle with all doors closed and the key in the ignition. Turn the ignition on and off eight times within ten seconds, ending with the key in the "on" position. The doors should lock and unlock, indicating the vehicle is in programming mode. Press any button on the remote to program it, and the locks will cycle again to confirm successful programming; repeat for additional remotes.
To program a keyless remote for a 2005 Toyota Sequoia, first, sit in the vehicle and close all doors. Insert the key into the ignition and turn it to the "On" position and back to "Off" five times within 15 seconds, ending in the "On" position. After the doors lock and unlock, press the "Lock" button on the remote. The locks will cycle again to confirm successful programming; repeat the process for additional remotes.
I have a RAM 3500 and the "how to program a new remote is in my owners manual under remotes" On the 3500 the info starts on page 23 and the actual programing instructions is a couple of pages further than that. I could type the info but you should be able to find the stock owners manual online too.
Animation Program - 2005 was released on: USA: January 2005 (Sundance Film Festival)
To program a 2005 Honda Element keyless remote, begin by sitting in the driver's seat and closing all doors. Insert the key into the ignition and turn it to the "On" position (not starting the engine) and back to "Off" five times within 10 seconds. Then, press the "Lock" button on the remote; the doors should lock and unlock to indicate successful programming. Repeat this step for any additional remotes, and finish by turning the ignition back to "On."
To program a 2005 Hyundai XG350L keyless remote, first, sit inside the vehicle and close all doors. Insert the key into the ignition and turn it to the "On" position (not starting the engine) and back to "Off" five times within 10 seconds. After the fifth turn, the locks should cycle, indicating the vehicle is in programming mode. Press the "Lock" button on the remote you want to program; the locks will cycle again to confirm. Repeat for additional remotes if needed, then turn the ignition to "On" to exit programming mode.