how do you program keyless remote for 2004 Kia Sedona
This may work for other cars and years....
From 1/16/02.
1.Open the hood and locate diagnostic connector near the battery.
2.Jump pin 5 to pin 17. (see below for explanation)
3.Turn ignition switch to on position.
4.Press lock button of first transmitter two times.
5.Press lock button of second transmitter two times.
6.Turn ignition key to the off position and remove the key.
7.Disconnect jumper from the diagnostic connector.
8.Check for lock and unlock operation of both transmitters.
P.S. the connector is shown with pins 1-2 side by side at the top left, then a big gap, then 3-4 on the far right. The second row picks up pins 5-12 from left to right. 3rd row is 13-20 from left to right.
Hope this helps everyone.
I have 2002 Kia Sedona and i purchesed without keyless remote ,than i bought on eBay for $20, i read every where how to work and how to program and i have luck, it is for 2002 only ,,,,, conect wire to + in your batery than connect terminal 17 on your diagnostic connector , go in the car and put key to on position than press lock button on your remote 2 times (each time 1 sec approx) turn key off take key out and disconect wire from terminal 17 and you good to go 100% will work, if you have problem email me directly z_j1@msn.com, thank you
How do i you program keyless remote for a 2004 malibu?
how can i program a remote for a 04 kia spectra
You have to program it with a DRB (Scan tool).
try following instructions @ www.programyourremote.com
see also 2004 silverado
I found an Internet site which says how to program the keyless entry remote. But there is an error: this procedure is good for Elantra 2001 to 2003. Elantra 2004 must be programmed by the dealer. http://car.justanswer.com/hyundai/n1kw-program-remote-entry-hyundai-2004
My 2004 land rover discovery 2 doesnt work?
Take the vehicle to a dealer. Not a consumer option.
You need one of these: http://en.wikipedia.org/wiki/Amstrad_CPC_664
one hr of labor like $45.00
all gms with a stock radio keyless remotes get reset though it, again it is step by step in owners manual
you need to take it to a dealer or repair shop because you have to do it using a computer.