NOTE: Make sure remote batteries are OK
NOTE: All How_do_you_program_remote_control_for_ford_escape_hybrid_2005remote transmitters (15K601) must be programmed at the same time.
NOTE: All previous transmitter identification codes (TIC's) will be erased when programming mode is entered.
NOTE: To program (or reprogram) the keyless entry remote transmitters into the generic electronic module (GEM)(14B204), carry out the following steps.
Turn the ignition from OFF to RUN eight times within 10 seconds, ending in RUN. If the GEM has successfully entered program mode, it will lock and unlock all the doors.
NOTE: The first TIC must be entered within 7.5 seconds of entering the program mode and additional TICs must be entered within 7.5 seconds of the first TIC. The programming mode is exited whenever the timing constraints are not met.
Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed.
If the door locks do not respond for any keyless entry remote transmitter, wait for several seconds and press the button again.
Turn the ignition switch to the OFF position, or wait up to five minutes after step 1, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the GEM will lock and unlock all the doors one last time.
The cast of Remote Control - 2006 includes: Osita Iheme Amaechi Muonagor Chinwe Owoh
The cast of Remote Control 2 - 2006 includes: Osita Iheme Amaechi Muonagor Chinwe Owoh
you have to take it to the dealer
You have to have a scan tool.
how do i program it
take it to the dealership doche bag
With the dealers scan tool.
You cant take to dealership. Thats the only way sorry
Well, you have 2 keys. one remote with buttons and one valet key with no buttons and no remote controls. The one with buttons have 2 forms of programming required. First, for the remote function to control the doors and/or windows, the second to start the car itself with the key in the ignition. You can program the remote function yourself with a door procedure, however ,the key itself can only be programmed by the dealer for the car to start. The same programming applies to the valet key.
go to http://www.programyourremote.com/ they have programs for many makes and models
You have to take it to a dealer and have them re-program it. My husbands dad works for a dealership and we tried to have them tell us how to do it but I believe they have to hook it to their computer to do it.
Look in your owners manual to see if anything is in there about programming it and if nothing you will have to let the dealer do it.