if u have the belt cover witch will be were i began first u have to get the belt of witch is a easy task prop the belt up on to the secondary clutch pull the belt tords u and at the same time turn the primary clutch from the front to back now that the belt is of u need to get a clutch puller from a dealer u need 2 difrent ones one for the primary clutch and one for the secondary clutch take out the bolt in the center of each clutch insert the threaded puller in to the center of the cluth and turn it till the clutch comes of
Yes, should be one on the right of the quad
step on the foot brake. then pull the shift lever to the desired gear.
There is also an adjustment, on my Sportsman 450, on the cable near the throttle. Pull rubber boot back.
The alternator, or stator, is behind the pull-start cover on the right side of the engine.
Turn the clutch by hand!
Remove the bolt from the crankshaft. You will need a puller to remove the clutch. I can tell you how to make one, Let me know.
You have to pull the front clutch off to get to the rest of the bolts...
the spark plug is located directly under the gas tank, If you pull off the left side pannel you wlll be able to see the wire.
Explain adjusting pull type clutch on Montero
On the very top of the engine... and not easy to get to must pull off side cover to access also use tools that came in kit with bike they are the correct length to get at it
The term "pull in the clutch" means squeeze the clutch lever to the handle bar to disengage the clutch. Hope this helps.
If you are using electric start then check the battery. If you can't pull it over try turning the drive clutch by hand. If you can't do this then the motor is most likely seized.