Want this question answered?
where is the crankshaft sensor located on a 1988 cutlass supreme
That year did not use are even have a crankshaft sensor.
POSSIBLE CRANKSHAFT POSITION SENSOR.
in the distributor in the rear of the engine. sometimes known as a hall sensor
Top driver side of the bell housing.
if it has a crankshaft sensor that's bad
It on the back of the coil packs going into the side of the block.
Yes mine did same thing it was the crankshaft sensor located on the firewall side of the engin.
You have to dismantle the entire engine,,,NO YOU DO NOT ITS JUST YOU HAVE TO DRAIN THE OIL TAKE THE OIL PAN OFF AND GET THAT DANG SENSOR TAKEN OUT THEN REPLACE IT!!
Check for code in computer Usually a crankshaft sensor does the same thing is culprit,but have scanned first
crank position sensor is between oil filter and starter, follow wire from module
To replace the crank sensor you have to remove the harmonic balance taking special attention not to damage the pulley or the cam shaft. Remove the two 10mm retaining screws