take the gas tank out, it's inside. piece of cake.
Just unclamp hoses, pull them off, and put a new one on.
Drop the tank, undo the ring on top and pull it out. How and where is the fuel pump on 1995 villager? Do I need to drop the fuel tank when I replace the fuel pump? Pls help me get answers? How and where is the fuel pump on 1995 villager? Do I need to drop the fuel tank when I replace the fuel pump? Pls help me get answers?
Pull the latch.
Pull off the vacuum hose. If there is any gas present in the hose, it's faulty.
Not without a specialized scan tool.
To remove the seats in the Mercury Villager you first need to pull the side lever and push the seat forward. Next, pull the release strap. Lift the back of the seat until the seat clears the latch. Pull rearward and remove from the vehicle.
Pull the clips back and lift them off.
Pull the hood release under the dash at the left side.
To change the thermostat on a 2002 Mercury villager, pull the hose away. If the bolts do not come off, wiggle the fitting to expose the thermostat to be able to change it.
With engine running, pull the fuel pump fuse or relay. The engine will eventually stall and leave little fuel pressure in the system.
That depends by what you mean by "fully loaded". It is not rated to pull more than a ton or so.
Fuel pump is located in the gas tank and cannot be reset. I had to pull the gas tank out to replace the fuel pump which took about 3 hours. I have not done this before so a trained mechanic should be able to do this in 1.5 hours. the reset switch is under the hood latch on the drivers side