answersLogoWhite

0

How do you put a distributor?

Updated: 12/14/2022
User Avatar

Wiki User

12y ago

Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you put a distributor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you put distributor in 2002 blazer 4.3?

how to install a distributor


How many hours to put in a distributor in a 4.3 s-10 2002?

How many hours to put in a distributor in a 4.3 s-10 2002?


You put a 305 in your camaro it has a carb do you have to change the distributor to a hei?

No, you don't have to change to the new distributor if you don't want to.


How to Adjust timing 97 Jeep 6-cylinder?

Distributor timing is adjusted by rotating the distributor. A scan tool is required to put the engine computer in distributor sync mode. The distributor is then set to zero degrees.


How do you remove the distributor on a 4 cylinder Chevrolet Celebrity?

To remove the distributor on your Chevy Celebrity 2.5L 4 cylinder engine: 1, Set the timing to the number one cylinder in the firing position. 2. Remove the distributor cap and put out of the way. If you take out any of the spark plug wires make note of where to put them back. 3. Loosen and remove the retainer clamp and its bolt. 4. Pull the distributor out of the block. To reinstall the distributor reverse the instructions. You will need to re-time the engine when you put the distributor back in.


Does a 77 350 have point?

Not unless someone put a breaker point's distributor in it. It had an HEI / HIGH ENERGY IGNITION distributor in it from the factory.


Will a distributor off of a 1991 Honda Civic fit a 1992 Honda Civic?

Why do you want to put an OBD0 distributor in a OBD1 motor?


What happens if you put the distributor cap the wrong way around?

Could damasge the distributor/hall sender leading to a starting fault.


What is a dizzy in your Honda Accord?

'Dizzy' is a lazy way to put 'distributor'.


Why is vacuum advance on distributor hitting the intake manafold on small block Chevy?

The distributor is off a tooth or two. You can pull the distributor out and turn the rotor a little and put it back in. Then re-time the engine.


When installing a distributor in a 94 s10 4.3 which way should the wires on the distributor face?

Depends some distributors are vertical some horozontal put the plug end in with wires facing away from center of distributor


Can you put a tach on a stock 87 Chevy 305 distributor?

Yes you can no problem.