answersLogoWhite

0


Best Answer

The spring side faces the engine

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you put a radiator thermostat in and which way does it supposed to be?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a thermostat on a 1996 Ford Thunderbird?

Follow the top Radiator Hose from the Radiator to the engine and you'll see a housing remove the bolts from the housing and there is your thermostat (Note the way it came out and replace it with a new one) make sure you know which way to put it back in


How do you change thermostat on a 2004 Chevy Impala?

Drain the radiator down 1/2 way. At the engine end of the top radiator hose is the thermostat housing. Remove the housing and install a new thermostat.


How do you replace thermostat on 1995 ranger xlt?

follow the top radiator hose to the engine, it will be attached to the therm housing, remove the therm housing and the you will see the thermostat, put it back the way you took it off


How do you change the thermostat on 1997 V6 Chevrolet Camero?

Drain the radiator down half way. At the engine end of the top radiator hose is the thermostat housing. Remove the hose and 2 retaining bolts and remove the thermostat. Clean the surface good and install the new thermostat. Refill the radiator.


How do you replace the thermostat on a 91 Acura Legend coupe?

The way to replace the thermostat on a 91 Acura Legend Coupe is to drain the radiator and remove the throttle and cable box. Remove the top of the radiator hose and the bolts. The thermostat will be inside.


How do you change the thermostat on 2000 Chevrolet Impala?

Drain the radiator down 1/2 way into a container. Remove the top radiator hose from the engine end. The housing is where the thermostat is located. Remove the 2 bolts and the housing. Remove the thermostat and clean the surfaces and install the thermostat.


How do you take a thermostat off a 86 trans am?

ThermostatJust locate the thermostat housing ( that's where the top radiator hose attaches to the engine ) remove it and the thermostat is inside. Be sure you put it in the correct way and clean off all the old gasket before putting on a new one


How do you replace the thermostat in a 93 Mitsubishi mirage ls . and where is it located?

Very simple, follow the top radiator hose to where it ends, there will be a silver thermostat housing there with 2 bolts. Remove the 2 bolts and replace the thermostat. Make sure you put it back in the same way it was taken out.


Where is the thermostat in Ford E-250 van?

If you have the 4.9L engine it it located on top in the front of you engine. Best way to find it is to follow the top Radiator hose from the radiator to the engine. It connects to the thermostat housing!


How do you replace the thermostat located on a 1993 Full Size Chevy Van?

The top radiator hose connects to the engine through the thermostat housing. Remove the radiator hose from the housing, remove the two bolts that hold the housing to the block, remove the thermostat from the housing, clean the housing and the block, put a new thermostat in (following the directions for orientation as specified by the box with the spring assembly TOWARD the engine.) Then after you have re-installed the thermostat housing and the radiator hose, add coolant and be on your way. While you're at it, check the radiator and heater hoses for brittle rubber or bulging spots and replace the hose if there is any evidence of damage.


Where is the thermostat located in a 1987 Honda accord lx?

the thermostat is located on the passenger side of the car if you are looking directly at the engine after raising the hood it is on the end of the upper radiator hose in the housing simply remove the two bolts and remove old thermostat and put the new thermostat and rubber gasket in the same way old came out


Where is the thermostat on a 97 Chrysler lhs?

The thermostat in the 3.5 engines is located on the front top, under the small fitting to which a rubber hose from the radiator goes. Replacement thermostats generally come with a gasket. When taking the bad thermostat out, note which way it points. You can doublecheck when installing if the new thermostat has the label "to radiator" on it.