The top radiator hose connects to the engine through the thermostat housing. Remove the radiator hose from the housing, remove the two bolts that hold the housing to the block, remove the thermostat from the housing, clean the housing and the block, put a new thermostat in (following the directions for orientation as specified by the box with the spring assembly TOWARD the engine.) Then after you have re-installed the thermostat housing and the radiator hose, add coolant and be on your way. While you're at it, check the radiator and heater hoses for brittle rubber or bulging spots and replace the hose if there is any evidence of damage.
THE THERMOSTAT IS ON THE BOTTOM HOSE BEHIND OF THE ALTENATOR. ITS A B1T
i need to find location of fuel filter on 1993 Chevy cavalier
The thermostat is located in the water pump behind the timing belt plate cover. the thermostat is in the bottom rad hoase where it conects to the motor.
Almost all thermostats are located at the motor where the top radiator hose connects to the motor. Drain the coolant, remove the 2 bolts in the thermostat housing, replace the thermostat, and replace the housing and refill the radiator.
Should be in a removable housing at the engine end of the upper radiator hose
1992 Lexus es300 wear the thermostat is located
That engine requires a 195 degree thermostat in it.
Under the thermostat housing
where do the thermostat go in my 93 buick lesabre
Follow the top rad hose to the engine , There you will find the housing undo bolts , clean gasket on housing replace with new gasket and thermostat. Make sure engine is cool and drain anti-freeze first
The thermostat is at tje engine end of the upper rad hose, When replacing it make sure the spring goes toward the engine.
The thermostat is located at the other end of upper radiator hose.
The 1993 Oldsmobile Cutlass Sierra thermostat is located on the front of the engine. You can follow the water supply line from the radiator to the thermostat housing.
Thermostat is located on right side of engine where the top water hose connects to the block. Disconnect water hose from engine (put a pan under car to catch anifreeze that will drip out) Two bolts hold the housing on. Thermostat will be setting in the opening to block. Tap gently with small hammer to losen an remove. Replace with new thermostat, run some sealant carefully around base of housing and tighten bolts back up. 1993 Chevy Lumina APV Van
trace the lower radiator hose to the engine, that's where the thermostat located.
The 1993 VW thermostat can be found on the front of the engine. You can follow the top radiator hose directly to the thermostat housing.
On a 1993 Toyota Camry Vienta, the thermostat can be easily located by following the lower radiator hose to the point where it attaches to the engine. When replacing the thermostat, always replace gaskets as well.
Where is the horn located on a 1993 chevy blazer
Follow the top hose back to the thermostat housing.
Replace your thermostat.
get another one and put it in
Follow the top radiator hose to the engine. You have just found the thermostat housing. Remove the 2 bolts and replace the thermostat and gasket if your engine uses a gasket. Be sure to note the orientation of the original thermostat before removing it.
follow the top radiator hose and it should lead u right to the thermostat housing. remove the housing and the thermostat is inside
The thermostat on a 1993 Ford e 350 7.3 diesel is located on the side of the engine. The thermostat can be found by following the upper radiator hose.