0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace the alternator on a 1995 Mazda mx6?
Take it to a mechanic.... use a 12 mm extended ratchet to loosen the accessory belt tensioner (remove belt) Unbolt the alternator from the engine chassis and unplug the positive and negative terminals. New Alternator Costs about $200, New Starter Costs the Same.
Where is the location of the safety fuel shut off on a 1991 Mazda mx6?
The safety fuel shut off location on a 1991 Mazda MX6 is under the dash. It is on the far right side in front of the passenger seat.
In what years did Mazda produce the MX6 automobile?
Mazda produced the MX6 automobile for the first time in 1987. They then released the second generation model in 1991 and this was in production until 1997.
What should you do when the battery charge light on the dashboard comes on in a 1994 Mazda MX6 Mystere?
Change your alternator
What would cause a Mazda mx6 not to start?
plenty of things could be a starter, alternator, ignition switch, bad spark...
Where is the tension release bar to put the alternator belt on a 1993 Mazda Mx6?
ok buddy , i am talking about 1993 Mazda mx6 4 cyl. when you look down you can see the one side of the alternator . put your hand on the back side which you can't see you will find a mounting bolt .you will feel it with your hand . that needs to be loosened first before you can loosen that the long tension bar . good luck , i just replaced the drive belts today ...ouff azzaro
Where is the fuse box in a 1991 Madza MX6?
Hi there, I can't say for certain, but on my 1992 Mazda MX6 it's located directly beneath the bonnet release lever. .
Does a 1994 Mazda mx6 have a tming belt or timing chain?
On a 1994 Mazda MX-6 : Both the 2.0 liter four cylinder engine and the 2.5 liter V6 engine have a timing BELT
Is 1993 Mazda mx6 moon roof interchangeable with 1995 Mazda mx6?
mx6 got no moonroof - only a sunroof and YES its interchangeable
What keeps timing belt tight on 2.0 Mazda mx6 is it just the spring on the tensioner?
first the spring puts tension on the belt, then you tighten the tensioner assembly and it hold there.
How do you replace the oil pressure switch for 1995 Mazda MX6?
Hi there , I have just changed the pressure sensor switch on my MX6 , it is located fairly centrally on the engine facing the radiator.There is a small wire that is routed across the alternator so it can be found by tracing that .I had to change the alternator and broke this by accident , you might have to remove the alternator to get to it first depending on the size of your hands and arms ,Mazda has the replacement parts and can be bought for a few pounds .Hope its helpful !!
What is the fireorder for a Mazda mx6?
1,2,3,4,5,6
