Asked in Needs a Topic
Needs a Topic
How do you put retaining clip back on?
We need you to answer this question!
Asked in American Cars
Why wont a cv shaft go back in the transmission on a 2000 for focus?
Asked in Windshields and Wipers, Toyota Avalon
How do you replace windshield wipers for a 1996 Toyota Avalon?
How do you remove the gear stick knob from a Renault Clio?
Asked in Peugeot 307, Peugeot 206
How do you remove rear wiper arm from peugeot 206 sw?
How to remove 1992 Nissan truck inside door handle?
There is a spring clip that holds it on. Take a paperclip and bend the end about 1/8 inch at a right angle. Press the door panel in and you will see the clip on the backside of the door handle. One end is looped. slip the paperclip into the loop and pull. The retaining clip will slide out and the door handle will come off. To put the handle back on just. put the clip back in the slot on the handle and press it onto the shaft.
Asked in Toys, Target Shooting, Nerf Toys
How does a Nerf gun shoot?
A Nerf gun works by using a burst of air to push the darts out of the barrel. Here's how it is accomplished: IN every Nerf gun, there is a barrel, a plunger covering it, and a spring behind the plunger. When the slide or bolt is pulled back, A notch on the plunger catches on a retaining clip which is placed behind the plunger. The retaining clip holds the plunger in place, a dart is inserted/put in front of the barrel, and the slide or bolt is brought forward. A piece of plastic block the barrel until the slide is completely forward, which pushes the dart into the barrel. This only is found in guns that use clips. The spring behind the plunger wants to push it forward, but the retaining clip won't let it. when the retaining clip is pushed up, the plunger is released, and it shoots forward, pushing air through the barrel and also pushing the dart out. the retaining clip is released by the trigger, which has a slant on it that pushes the clip up.
Asked in Chevy S-10
How do you put the window crank on a 1955 Chevy belair?
How do you replace front brake pads on 2005 ford f150?
Unbolt the caliper from the frame.remove the clip holding pads together.remove old pads with a screwdriver.open cap to brake master cylinder.use a c-clamp and 1 old pad to push caliper piston back flush.clean caliper surfaces with wire brush reapply brake grease to the slide areas and put new pads in calipers. Put retaining clip back on and carefully put caliper back over the rotor and put bolts back in.good luck
Asked in Electric Windows, Chevy Blazer
How do you put a power window of a Chevy blazer back on track?
Asked in Chevy Silverado, Fuel Filters
How do you remove fuel line quick connect retaining clips?
what you do is EASILY pull the hose and the retaining clip together ( like you are putting the hose back on the clip) when the hose is as far as it will go you have to squeeze the 2 white or grey retaining clip together. at the same time slowly slide the hose off. Make sure the clips are in good shape b/c if your changing the fuel pump you have to reuse them clips. Let me know if this helps you JLamond219@Yahoo.com
Asked in Pontiac Aztek
Where can you get a headlamp retaining clip for a Pontiac Aztek?
Asked in Car Sounds, DIY Projects
How do you remove the rear radio panels on a ck 3500 crew cab?
Asked in Ford Explorer XLS
How can you remove a 2005 Explorer rear wiper arm?
Asked in Auto Parts and Repairs, Kia Sportage
How do you put the window back on track in a Kia Sportage?