Which spring?? Which pistol??
Need make , model of "gun" hi-point c blue 9mm se
No, it is much too large.
No
9mm and 380 both use bullets with a diameter of .355. However, the cases are a different size. .380 is also known as .380 auto, 9mm Kurtz, 9mm Corto, 9mm short or 9x17. 9mm typically refers to 9x19mm also known as 9mm Parabellum or 9mm Luger. You cannot fire a 9mm Parabellum cartridge from a .380 handgun. The 9mm cartridge will not fit into the chamber of the gun. However, if you were to pull the bullet out of the .380 case and put it into a 9mm Para case the resulting cartridge will work just fine.
You must first buy a new spring or spring kit. Take off the barrel, hopper and air. Then you remove all the screws keeping the receiver together, and remove one half of the receiver. remove the back cap and take the old spring from the guide pin, put the new spring in the back of the bolt, put the pin in, and feed it into the back cap. then reassemble the gun.
you put the primer forward to create elastic potential the put the trigger to turn that to kenetic and sound energy
Release of a spring from compression Recoil of gun after firing a shot
You could buy a weaker spring.
yes you just need to put a worse spring in it
Take it to a gunsmith
alright, first you need to separate the gun into two pieces. Start by holding down the orange button on the right side of the gun. While you hold down the button, on the left side of the gun, turn the metal lever in front of the safety 90 degrees clockwise. The orange button and the lever can now come out. Hold the gun like you would cock it except pull them apart. Now the barrel and the trigger should be apart. The way daisy put this gun together makes it hard to remove the spring and the spring stopper. You will need two screwdrivers, first you need to separate the spring and the spring stopper. While one screwdriver pulls the spring towards the barrel, put the other in the back of the spring stopper and pull the spring stopper out from the bottom of the tube that holds it. ( The plastic is weak and should bend without breaking. After the stopper is out, all you need to do is pull a small bit of the spring out then spiral the rest of it out.
The Internal Magazine is the compartment that holds the BB's ready to be fired. It usually comes out of the gun and you put the BB's into it then put it back into the gun.