Want this question answered?
The codes 1 -20 on the reset dash display for a D4D is used to explain what is wrong with the system. You will need to use a code reader to get the specific code and find out what is going on.
OBD2 code reader plugged into port under dash, disconnect batt for a while. Note-clearing codes without repair will result in fault reoccuring so light will continue to come back on
try disconnecting the battery for a minute.
No, When You Have The Codes Unloaded In A Garrage.:From The Car Computer And See What Is Going On , Repair These. Sometimes Flukes. It Will Reset.
Remove the negative battery terminal (-) for about 15 minutes and most codes will reset.
To reset on dash board lights, you must disconnect BOTHbattery terminals and touch them together to reset all codes
The airbag light can not be reset. The light stays on when a malfunction has been detected. You need to have the computer checked for codes and the failure repaired to get the light off.
do you have 2000 mazda 626 dash board?
check the owners manual. if you have one with the nav display in the center of the dash you will reset it through there. There is no oil change light in the instrument cluster.
When a dash warning light needs to be reset follow the same process of resetting an ECU. If there is no diagnostic tool on hand disconnect the battery for 5 seconds and the computer will reset all codes and lights.
Could be a faulty fuel pump. If the check engine light illuminates, check for codes. The codes may help you find the cause.
Turn key off ,push and hold reset button on dash,turn key on continue to hold button until light goes out