0
Just replaced the rear pads and the brake light is still on how do you get it to go off?
Wiki User
∙ 14y ago
To reset on dash board lights, you must disconnect BOTHbattery terminals and touch them together to reset all codes
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
1995 subaru legacy outback Why is brake-battery light on just replaced battery and alternator but brake-battery light still on goes off when car is idle but comes on when you press gas pedal?
Put some brake fluid in the master cylinder.
How do you reset the brake wear warning light on a 2007 S550 after all pads and wear sensors have been replaced?
just peplace front brake pad and new sensors on my s550 mercede but the sensor light is still on how do i get it to go off
Where is the brake light located on a 2001 sable wagon?
Other than at the back of the car... (?) If the question is about how to change brake light bulbs, See "Related Questions" below If the question is about the brake light switch, that's on the brake pedal - just a couple of wires going to it and rather easily replaced.
Brake light only work on top of hatch on 1997 jimmy gmc replaced bulbs?
There might be a separate fuse for the lower brake lights ( just a guess )
How do you fix your brake lights when they won't turn off?
Probably a brake light switch problem. May be able to adjust, or may need to replace. I just replaced the brake light switch in my 1998 Mazda Protege LX and the problem came back. I believe the cruise control could be shorting out the brake light switch.
What are the reasons other than fuses and bad bulbs for brake lights not working on Daewoo Leganza?
I just had my Daewoo Leganza brake light switch replaced. It goes under the brake pedal. and now my brake lights work fine.
2001 VW Beetle and the brake lights do not work. The fuses and the bulbs are all fine you just replaced the brake switch and the brake lights still do not work what else could it be?
a crappy car. my 99 beetle has the same problem. brake light switch new, bulbs and fuses new. brake lights just work whenever the heck they want. this is one of the many reasons my car has a for sale sign in the window. good luck.
Is there a middle brake light on a 2000 Chrysler 300m or is it just a tail light?
No, it is a brake light.
What if my traction system light and abs light goes on at the same time and there is resistance in the brake pedal som of the time?
Your front rotors are probably shot, they have a sensor in them that controls the traction light. I just had mine replaced on my 2002 because the traction light would come on for no reason, just sitting at a stop light and pulling out, backing up. Does not do it now since I had them replaced!
How do you replace the bulb on the right side for brake light on a 1995 Geo Tracker?
Remove the Phillips screws holding the lens in place, remove the lens, push bulb into socket and rotate counter-clockwise, reverse procedure to install. There are three light bulbs when the brake light column is taken out. If just my brake light is out, which bulb needs to be replaced?
How do you reset the brake pad warning after changing the brake pads on a BMW?
Just turn the key to on (second) position - where you see all the lights come on the dashboard and wait till the brake wear indicator light go off. If you replaced the tripped brake wear sensor, the light will go off in about 10-15 seconds...
When my brake pads and rotors were replaced on my 1995 infiniti g20 the brake light extinguished but the abs light goes on and off and brakes pulse at different times when the light is on?
take it to the dealer tell them you just want a diagnostic performred. see what they say posibly you can do the repaires yourself. but have this checked out.
