If the window regulator cable has failed, the entire regulator will have to be replaced.
No, you cannot usually fix or repair a power window cable. The ends of the cable are pressed on with a pressing machine. A person has to buy a whole new track and cable setup.
They have cable driven regulators. Over time the cables either break, or get bound up which breaks the plastic pully. You need to replace the regulator. I have replaced my drivers door 3 times. Passenger door once, and both rear doors once. It is easier to replace them as an assembly. (Motor and regulator together). If you only do one or the other, it can be difficult to respool the cable to the pully if it should come off.
You will have to replace the complete window regulator assembly.
window regulator cable is broken need new regulator
A cable actuated car has a device that allows for the tension differentials which may occur in the actuating cable sections. It also has an uneven window glass top edge against its window frame.
it attaches to the bottom of the window by way of a clamp.
To fix a cable on an electric window on a 2004 Chevy Epica you need to first gain access to the wire by removing the door panel. From there, you can either fix or replace the cable.
Probably for the rear window defroster
A rear electric window that has jammed on a Renault Megane Dynamique might be termed off cable. This means that the mechanism for raising and lowering the window (the cable) might need to be replaced. To replace the cable, the door panel needs to be removed.
Either the window is rubbing against the worn out weather stripping or the cable that moves the window up and down is dried out. Try taking the inner door trim off and put some light oil on the cable and sliders.
replace window regulator assembly.