Rebuilding an ATV top end takes some knowledge of engines. Check out my bio page for help.
No, the pinions do not turn in the same direction
Hypoid Gear Oil 80/90
you are so dumb!
depends on if your doing the top or bottom end. TOP END: about 200 bucks if you do it yourself about 400 to have it done BOTTOM END: about 350 do it yourself about 450 have it done. email me with any questions peewadin@aol.com
26.5hp but plenty of torque and low end
Plug one end to the Petcock and the other end to the Carburetor......
what is the housepower of the 2009 handa rancher at 420 It has around 26 or 27. But a lot of low end torque for MUDDING!
get a clymer manual for torque specifications.
On 350 rancher it located in the back I took the engine off I was told it could be done with out removing it but it wasn't that hard pulling the engine. you have pull the top end off so you can pull the cam to change chain. any questions email me I just did mine Bob pooleb@ns.sympatico.ca
Mostly hanging on the end of the cam shaft, but check the fuel tank.
the switch is inside the back cover, but you should check the shift drum. the end of the shift drum has a slot in which the neutral switch sets in, and on my rancher the end of the shift drum was broke so when the quad is in neutral the switch said it was in gear you pretty much have to completely disassemble the whole engine and tranny to change the shift drum. good luck
Sounds like a rod bearing. Time for a rebuild job.