answersLogoWhite

0

  • Starters and Ignition Systems
  • Toyota 4Runner
  • Ford F-150

How do you reconnect a starter on a 90 Toyota 4runner?


Top Answer
User Avatar
Wiki User
Answered 2008-04-08 19:24:42

ya u have to go under the right hand wheel well and there should be a little plate on the wheel well take it off and it should be about 3 or 4 bolts and that gives u acsess to the side that the starter is on easy to get out in stead of pulli a bunch of stuff off and pulling it up threw or down lol

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Why don't my fuel gauge work on my 90 Toyota 4Runner?

its broke


What are the torque specifications for the head bolts on a Toyota 4Runner 3.0 V6 cylinder?

33 ft lbs and then 90 degrees then another 90 degrees in an x pattern


How much for a diagnostic for a Toyota 4Runner?

Is the check engine light on? What is the vehicle doing? Normal a shop well charge anywhere between 90 to 120 bucks.


How do you install a starter on 1987 Toyota?

I had a 90 and 91 so I assume its pretty similar. Undo the negative battery cable first of all. The starter has two bolts that mounts the starter to the engine and an electrical connector that supplies power. First, undo the electrical connector. These are all a little different but usually there is a small tab that has to be depressed and then the connector slides out of the sleeve. These are a male/female type connector. Now, remove the two bolts and wiggle the starter until it starts to come out of the engine. You've got the hard part done now. Put the new starter in, install the two bolts, reconnect the connector, and reconnect the negative battery cable. You're done.


What kind of brake fluid goes into 90 Toyota 4runner?

Dot 3 or Dot 4 doesnt really matter. They are so close in comparison, a normal user will never reach the temperatures that either is rated for.


What kind of tramission fluid does a manual 90 4runner use?

75w90 gear oil


Where is the starter located on a 90 Corvette conv?

I have a 90' ZR1 and the starter is under the plenum a costly job about $700 plus parts. They have to remove the top of the engine to get to it.


How do you replace a stator on a polaris 90?

Remove the starter cables. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.


Toyota lucida head torque?

64 n/m + 90 degrees + 90 degrees


What do you get in a dinosaur king starter set?

You get 90 cards, a playing field, 1 rare card and a starter hand book.


How do you check gear oil on a 1993 Toyota 4runner?

If you are checking the rear end, there is a bolt on the back side of the pumpkin( facing the rear) Take the bolt out and there should be a thin trickle of gear oil running out. If not, put 80-90 gear oil in until there is a thin trickle running out.


What band sang fire starter in the late 90's?

Prodigy.


What is the cylinder head torque on a 1999 Toyota Tacoma 2.7 liter engine?

from a Toyota techfrom a Toyota tech. torque with torque wrench to 38 ft/lbs. then mark bolts with white paint like white out and turn additional 90 degrees. then another 90 degrees


How to replace a starter for a 90 geo prism?

You gotta get under the car and do it from the back of the engine.


Gas tank capacity of a 1993 Toyota t100?

approx 90 litres


How do you replace manual transmission fluid on a 1999 Toyota Corolla CE?

I just called Toyota, it uses 75w-90 Gear Oil.


What is the cylinder head bolt torque for 7k engines of Toyota revo?

21.4 ft/lbs(29nm) + 90 degrees + 90 degrees


How do you get a starter out of a fluorescent light tube?

The starter is asmall device which is generally connected in the Tube light frame in a suitable socket. Normally it can be rotated by 90' and be pulled out from its socket


Where is the starter relay on a 1994 Corsica?

my car 6 cylinde corsica 90 doesnt start what i do?


90' crx si starter motor is- there a relay in the solenoid housing the motor and solenoid were separately bench tested and were ok but starter doesn't work when installed any ideas?

get a starter switch from your parts store so you can hook dierctly to the starter when your under the hood sinc its dierect if it starts it most likely loose contact if it doesn't start check g.n.d.(-) and try 1s more


What is the cylinder head torque settings for a Toyota conquest 1300?

30nm -50nm -+90%


Where is and how do you remove the starter motor on your 90 golf gl?

Disconnect battery, starter is located somewhere by where engine meets transmission. Remove all electric connections then remove bolts securing starter. Install new starter, attach electric connections, connect battery and your done.


Where do you get a speedometer cable for a 90 Toyota pickup?

You can get a speedometer cable for your 1990 Toyota pickup truck at most auto-parts stores. Many Toyota dealerships have auto part departments open to the public.


How do you wire a starter on a 90 hp Johnson?

The starter should have two wires. The positive wire goes to the positive terminal on the battery. The ground wire can be grounded to anything that is metal.


What gear oil do you use for a 82 Toyota pickup 4x4?

90 weight gear oil.