Want this question answered?
hold the clutch lever in, rev the bike a little bit, then slowly release the lever until you start to move a little bit. when you want to shift, either mash the gears or i guess you could pull the clutch lever , shift into another gear, then release slowly.
hold the clutch lever in, rev the bike a little bit, then slowly release the lever until you start to move a little bit. when you want to shift, either mash the gears or i guess you could pull the clutch lever , shift into another gear, then release slowly.
700r4 gear shift lever want lock in place
cable broke or out of adjustment,you can manually release it by putting a ice pick in the mechanical release hole on the shift lever console in an emergency to get yourself going but you nmust get it fixed or readjusted.
The ability to shift out of Park is controlled by a Shiftlock Release micro-switch. You must have the key turned to acc or run position and step on the brake pedal to actuate the switch releasing the shift lock. Any failure of the electrical circuit to the micro-switch or a failure of the switch itself will prevent shifting from the Park position. It could also be caused by a weak or dead battery. There is a manual release button just ahead of and to the right of the shift lever. Press and hold the release button and then press the button on the shift lever to move the lever out of the Park position.
Yes there is. It is called a brake pedal interlock and the part number is 2609-4827
bark lever
The shift level is locked by the shift solenoid. When you step on the brake, the brake switch sends power to the shift solenoid and it moves a lever to unlock the shifter. If either the switch or solenoid is bad, you can't shift out of park.
It could be mechanical or it could be electrical. Sometimes if you park on a steep incline or park hard up on a curb, the shift will be difficult to come out of park but it should with a little extra pull on the lever. Also, check the fuses. many vehicles today must have the brake pedal applied to release the shift lever from park. If the fuse is blown that protects that circuit, the shift lever will not move.
check the brake pedal switch
On the right side of gear shift lever, there is a long narrow plastic bin probably 1 inch wide and about 3 inch long and 1.5 inch deep.Pull this bin up by grabbing inside.You will find a window below and a pink plastic tab.Gently push this pink plastic tab to release gear shift lever from park in case of emergency (only).
do not put any pressure on shift lever until brake is pushed. also lift shift lever directly up when placing into reverse.