Fuel and Fuel Intake
Chevy S-10
Chevy Blazer S-10

How do you relieve the fuel pressure on a Chevy S-10?

293031

Top Answer
User Avatar
Wiki User
2011-02-15 21:12:06
2011-02-15 21:12:06
s-10 fuel pressure releifOn later models, loosen gas cap. s-10 fuel pressure releifOn later models, loosen gas cap.

If the vehicle is fuel injected you can pull the fuel pump fuse or relay while the vehicle is running. It will run until the pressure has dropped.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

To relieve the fuel pressure on a Chevrolet S10, the fuel pump relay should first be removed. Then, the engine should be startedand run until it stalls.

User Avatar

The 1994 S10 has a fuel pressure regulator located in the throttle body.

User Avatar

The fuel pressure regulator is located in the throttle body.

User Avatar

Fuel pressure for a 1997 Chevy S10 with a 4.3L engine requires 60 to 66 psi.

User Avatar

Probably a bad fuel pump. Have the fuel pressure tested.

User Avatar

The 1998 Chevy S 10 Blazer 4.3 liter engine fuel pressure regulator will be on top of the engine. The fuel pressure regulator will be attached to the injector fuel pump.

User Avatar

A plugged up fuel filter, a faulty fuel pressure regulator or a faulty fuel pump.

User Avatar

It is attached to the throttle body. Pressure should be 41 to 47 psi.

User Avatar

The fuel pump may be running but it may not put out enough fuel pressure. Have the fuel pressure tested. I am assuming the fuel filter has been changed.

User Avatar

It is under the air cap and behind the fuel injectors.

User Avatar

It is on the fuel rail on the return side. The rail meaning where the fuel injectors attach.

User Avatar

The 1985 Chevrolet S 10 blazer fuel pressure regulator can be found on the top of the engine. The fuel pressure regulator will be near the fuel injector pump.

User Avatar

Cycle the ignition switch a few times from off to on, it will bleed itself.

User Avatar

Could be a faulty check valve in the fuel pump, a leaky fuel injector poppet or a leaky fuel pressure regulator. My guess would be the fuel pressure regulator.

User Avatar

The fuel pressure regulator is located under the upper intake manifold. It is attached to the bank of injector poppets, AKA the "spider".

User Avatar

We need to know the year and engine size to answer that one.

User Avatar

Inadequate fuel pressure. If that 2000 S10 Blazer has a 4.3 engine, it needs 61 to 66 psi (engine off with fuel pump running) to run properly.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.