1.Remove all 3 HVAC knobs.
2. Unscrew 2 screws inside pocket holding it to the trim panel, both screws are inside at the top.
3. Unscrew 2 screws behind temperature knob and vent selector knob.
4. Remove trim panel around radio and HVAC controls.
5. Unscrew 4 screws holding radio in place, two on left, two on right.
6. Pull radio out.
7. Unscrew 2 screws from adapters, one on each side.
8. Remove wiring harness and antenna cable.
The OEM stereo is chassis grounded, meaning the ground for the stereo is built into the case of the stereo, so when you install a new stereo you'll have to hook the ground wire to a suitable ground (I'd attach it to the screw from Step #5).
Connect the wiring harness to the back of your 2003 Mitsubishi Lancer CD player. Secure the CD player with the retaining bolts. Connect the ground wire.
First you remove the knobs for the Temperature, Fan, and vent control, and u will see 2 screws, remove those. After removing, gently pry off the dash panel, exposing the bracket for the CD player. Remove the 4 screws (2 on left and 2 on right) and gently slide out CD player. Before pulling out all the way, disconnect the harness and the antenna cable. To put in another CD player, use the same brackets, just remove it from the old CD player.
well i have a 2006 lancer and mine does not have them
Remove the cd player decorative cover. Remove the cd player retaining screws. Remove the wiring harness from the back of the cd player.
Remove the cover from your 2003 Kia CD player. Remove the CD player retaining screws. Remove the wiring harness from the back of the CD player.
Remove the decorative cover from your 2003 Lincoln Navigator CD player. Remove the CD player retaining screws. Slide the CD player out. Remove the wiring harness from the back of the CD player.
cd player
You can remove the CDs by ejecting the CDs from the CD player in the car.
Tweezers!
Begin by removing the cover to your 1996 Chevy Suburban CD player. Remove the CD player retaining bolts. Remove the wiring harness from the back of the CD player. Reverse the process to install your new CD player.
To eject a CD from the multimedia system in a 2011 Mitsubishi Lancer, press the "Eject" button on the CD player or multimedia unit. If the CD does not eject, ensure the vehicle is in accessory mode or turned on. If issues persist, refer to the vehicle's owner's manual for troubleshooting steps.
break the player