Begin by removing the cover to your 1996 Chevy Suburban CD player. Remove the CD player retaining bolts. Remove the wiring harness from the back of the CD player. Reverse the process to install your new CD player.
How do you replace a slave cylinder in a 96 chevey k1500
You will need to remove the transmission to replace the clutch slave.
YES you sure do.
The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.
To replace the slave cylinder on a 2002 Chevy Tracker, first, ensure the vehicle is securely lifted and supported. Drain the clutch fluid and remove the clutch line from the slave cylinder. Unbolt the slave cylinder from the transmission bell housing and carefully remove it. Install the new slave cylinder by reversing the removal steps, ensuring all connections are tight and then refill the clutch fluid before bleeding the system.
You will have to REMOVE the transmission and when you look in the bell-housing you will see the slave cyclinder. Remove the 4 bolts that hold it in place and replace it.
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
YES you do. It's all in the bell housing. No other way to get to it.
The transmission must be removed, and put back in, not replaced.
i have an s-10 myself and need to replace that too,but to answer your question i was told it is inside of the transmission.
You will need to remove the transmission and you will find it in the bellhouseing. There will be 4 10mm bolts that hold it on,
Which part do you want to replace? The slave cylider or the master cylinder? The hydraulic line and master cylinder.