Want this question answered?
First undo the plastic trim around the headlining, drop the headlining and then undo the 10mm or 13mm nuts. You do not need to take out the full headlining, just drop it in that area.
You need to first remove the 3 or 4 phillips screws located under the rubber close to the windshield. You can lift the upper part of the rubber and see the hidden screws. Once you removed all of them you can pry out the rails starting from the back in an upwards direction.
It is located on the firewall in the passenger's footwell. You have to remove the trim panel under the dashboard to see it.
yes , top can be removed. remove trim along bottom sides of top, also remove trim where front of top meets roof of cab then remove bolts that hold top to vehicle. then with some buddies, lift top off
To remove the headliner on the 1998 Ford Escort, first remove both of the visors by removing their screws. Then, remove the trim from around the edges of the interior roof. Then, pull the headliner down from the ceiling.
On newer models, you have to move the seat all the way forward, remove side trim cover, remove seat belt anchor bolt, remove seat rails retaining bolts, tilt seat upward, disconnect wires, remove seat...
First, remove all weatherstripping from the top of the door. Next, remove all torx screws a the top of the door and remove body piece. Then there are three phillips screws, remove them and the screw just below the windshield. Voila! To remove the rear trim piece, remove interior pilar cover, then the five screws behind it. Done est. Time 20min
Valley trim is usually installed onto the roof preceding the actual roofing panels. If you are using standard panels with W-Valley trim (or similiar) the Valley trim is screwed directly into the lathe using "Quick-Drill" (metal-to-wood) screws.
Move the seat all the way forward, remove the 2 bolts on back of the rails, remove the side trim cover, remove the seat belt retaining bolt, tilt seat, disconnect wiring, remove seat. (See Haynes Repair Manual # 24047).....
To change the headliner on the Mercedes C280, you will first need to remove all interior trim that covers the edges of the headliner. Then, remove the sun visors. Pull the old headliner from the roof and use spray glue to add the new headliner. Then, replace the visors and the trim.
pry the trim piece surrounding it straight off. that will expose the four screws which need to be removed. bend down the two metal tabs and remove module
To replace the headliner on your 1999 Dodge Ram 1500, you will first need to remove all of the trim and the old liner. Then apply the new liner glue to the interior roof. Then attach the new liner and add the trim.