I havea 1971 302 out of a passenger car. It requires a special puller that I dont have so I wound up bending it with the wrong type of puller. The new pulley is pressed on with a bolt like tool. you simply put the pulley on the pump shaft and thread the bolt into the hole in the shaft. As you tighten the bolt, you are pressing the pulley on. I think you could have a shop do this job for you for a small fee. It helps to have the pump off though.
It requires a power steering pulley PULLER, You can rent them at a parts store.
With a power steering pulley puller. This tool can be rented or bought from most auto parts stores.
You need a power steering pump pulley puller tool. This will remove the pulley, so you can get to the other mounting bolts.
How do you remove power steering pulley on a 1990 ck truck
How do you put the pulley back on the power steering pump on a 1990 suburban
you will need a power steering pulley puller other than that its gravy
how do you install a pulley connected to the power steering pump on a 93chevy camaro
to remove the tensioner first you need to remove the bracket that holds it. once you have removed the pulley bracket with the pulley still attached to it, 1 remove the retaining nut, and washers. 2 You will need to use a press to remove the bearing from the post.. 3 If you are replacing the bearings on the pulley you will need to remove the "C" clip retainer, and press the bearing out.
Power steering belt to crankshaft pulley. Alternator belt to water pump pulley and to crankshaft. A/C compressor belt to power steering pump and to crankshaft pulley. Smog/Air pump belt to water pump pulley. This is for a truck that had a 2 grove power steering pulley, a 2 grove water pump pulley and a 3 grove crankshaft pulley................
power steering pump failure ----------------------- If it is a Dodge truck then i see alot of Power steering pump shafts that are broken. To test, then pull on the power steering pump pulley - if it pulls out then you have a broken pump shaft.
crank pulley.
remove pulley - you need a power steering pulley puller and installer for ford - unbolt pressure feed line and bolts holding pump to bracket. Remove clip or clamp holding return line. Install new pump