Remove all fasteners behind the filler neck door that attach the upper filler neck assembly to the car body. Remove ground strap if applicable. Loosen and slide clamps up from tank end of filler neck then wiggle the filler hose assembly off the tank and out. Take care not to allow dirt and crud to enter the tank. Removing the clamp on the tank end of the filler neck assembly will be a test of your dexterity skills but it can be done.
You can not. There is an anti siphon valve in the filler neck. You have to remove the filler neck from the tank and drain from there.You can not. There is an anti siphon valve in the filler neck. You have to remove the filler neck from the tank and drain from there.
You have to remove the filler neck and hose from the tank then slip a siphon hose into the tank.
depend on year model. remove fuel tank cover if equipped. disconnect fuel filler neck hoses (2) remove fuel lines, feed, return and evap. remove fuel tank straps and remove fuel tank. recommend draining fuel tank before removal
there are 2 10mm bolts where the radiator filler neck mounts to the engine block, remove them and pull the filler neck off the thermostat is underneath
Remove the filler neck hose from the tank and insert a syphon hose.
This is a job that just about anyone can do. 1) block front tires and Jack up Left rear side of car. 2) Remove Rear Tire. 3) pull plastic cover that protects the filler neck. 4) undo hose clamps on the filler neck side of the robber hose that connects the tank and fuel filler neck on your stratus. 5) undo the 3 bolts at the top of the fuel filler pipe. 6) pull the filler neck our of the hose and put your new stratus, cirrus or breeze fuel tank filler neck back in place the same way taken apart.
Remove the present one by turning counterclockwise until it comes free of the filler neck, Insert new cap in the filler neck and turn it clockwise until tight.
there are 8 on a 6 foot s10 bed plus the filler neck
there are eight bolts you have to take out. you have to remove your fuel filler neck and take the ground wire for the tank loose then you have to disconnect your taillight wiring its easier to lift off if you take your back bumper off to
Large pair of channel locks
you can't there is a check ball that is located in the filler neck you must remove a line and try to siphon that way
I am currently working on mine and the way i see it is disconnect the filler neck and the wires and hoses. Then unbolt the holding straps and make sure you have a jack under it to keep it from falling on you