0
should be 4 bolts on bottom of seat
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is the voltage regulator on a 1991 dodge ram 150 pick up?
The engine computer, located behind the battery, is the voltage regulator on a 1991 D150 truck.
How do you change the master cylinder on a 1997 dodge Dakota pick up?
Remove and plug brake lines Remove electrical connections Remove mounting bolts Pull master cylinder off activating rod BENCH BLEED NEW MATER CYLINDER Re-install in reverse order
How do you remove a fuel pump from 1995 dodge ram 2500 pick up?
Remove the fuel tank or remove the bed.
How can you remove an ignition lock on a 1985 Dodge Ram Pick up with no key?
Drill it out............
Where is the drain plug found on the transmission of 1997 dodge 1500 pick up?
There isn't one. You have to remove the pan to drain.
How do you replace a flex-plate in a 84 dodge ram 150 automatic pick up?
The easiest way is to remove the transmission for that job
Step by step instuctions to change a heater core in a 1999 dodge ram pick up?
Remove the three 8mm screws holding it in
How do you remove the window crank on a 2002 Dodge Neon?
Their is a special tool to remove manual crank window cranks and it will work for almost any car. You can pick one up at auto zone
what are the differential ratios of the Pick Up Dodge Dakota year 2004?
80w90
You own a 1978 Dodge Pick up 318 engine and you need the wiring diagram to make some replacements. Where you can find it?
If you get a Hayes 1974-1993 Dodge Ram series manual, they have them in the back few pages in the electrical system section. They are a little hard to use because they are from the factory, but they help. Mine came in handy when trying to fipure out the fusible links in the blinker system on my 86 D150. Good luck
Did Chrysler ever make dodge pick ups?
Yes, Dodge is a part of the Chrysler corporation
What would cause a 1986 Dodge D150 to turn over and cut right back off?
Check your resistor Ok, its probably not the resistor. These trucks have dual ignition pick-ups in the distributor. the pick-up for the engine to run is most likely burned out, and needs to be replaced. Its a good idea to replace both or just buy a rebuilt distributor. Be sure to check the shaft for excessive play in the shaft, some rebuilders just replace the electronics.
