0
Somewhere in the belt path, is a tensioner. It looks much like the rest of the pulleys, but
is mounted on a spring loaded arm which swivels. Once you locate that, you can put a socket or other tool on it and move it so that the belt loosens. Pull the belt off while holding the tensioner.
NOTE: Check to see if you have a belt routing diagram somewhere under the hood. If so, good. There will be no problem replacing the belt. If not, make your own diagram of the belt routing so you can get it back correctly.
FriPilot
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change a water pump on a 2000 dodge RAm?
loosen the idler pulley and then remove the belt. then you remove the fan shroud i believe its like 4 bolts, then you remove the fan. after that you can remove the water pump.
How do you change a fan belt for a 2000 Toyota Avalon?
How do you change a fan belt for a 2000 Toyota Avalon
How do you replace a Ford Laser 1989 fan belt?
remove the old belt and remove your trouser's belt off and put into the fan
How do you replace the fan belt on a 2000 Mazda Miata?
There is no fan belt on a Mazda Miata.
How do you change fan belt on Mazda protege 2000?
The 2000 Mazda Protege has electric fans, hence there is no fan belt to change.
How do you replace a BMW alternator belt on a BMW 528i e39?
Remove fan clutch with fan impeller. Remove A/C compressor drive belt. Remove cap from tensioning roller. Relieve tension on drive belt. Remove drive belt. Reverse procedure for installation.
How do you remove and replace the fan belt on a 2002 Toyota Corolla?
it is no suh a thing is fan belt on 2002 corolla
How do you get the fan off of a 1996 Chevy Blazer?
REMOVE THE SINGLE DRIVE BELT, THEN REMOVE THE 4 MOUNTING BOLTS BETWEEN THE FAN AND THE BELT PULLEY. THE FAN MIGHT NEED TO BE WIGGLED OFF
Fan belt diagram Renault espace?
diagram FOR ESPACE 2.2 DIESEL fan belt fitting 2000 reg
How do you remove the plastic fan enclosure on a 2000 V6 Dakota?
remove the fan clutch and fan first
How do you change the fan belt on a 97 geo tracker?
Loosen the component slide it towards the engine to lossen the belt, remove belt. Install in reverse. If the fan is your problem it is held on with 4 small bolts, remove them and the fan. P/S you should be able to work the belt around the fan blades without removing the fan. On_mitch
How do change drive belts on a 2000bmw 4door 323i?
In order to change the drive belt on 2000 BMW 4 door 323I, you must remove the air filter box, loosen the hose clamp, remove the harness plus, and depress the clip to remove it. Unclip the hose from the air filter box and remove it from the vehicle. Next remove the fan and fan clutch assembly. Next remove the tensioner and remove the belt.
