0
Punch it in then pull it out with whatever means.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove freeze plug Chevy?
Punch a hole in the middle of the pug and pry hard it can take a lot.
Freeze plug location 1996 Chevy lumina 3.1 V6?
Where is the freeze plug. On a 1996 lumina3.1v6
Where are the freeze plug located at?
where is the freeze plug located on a 1992 Chevy beretta and I need a picture on it also
Mechanic cost to replace a freeze plug on a Chevy elcamino?
how much does a mechanic charge to replace a freeze plug on a chevy el camino 8.0
Installing freeze plug 1999 Chevy Malibu?
freeze plug location 9 9 chevey Malibu
Where is the freeze-plug located at on a 1997 Chevy Monte Carlo?
the car is smoking on the left side is it the freeze plug?
454 Chevy freeze plug location?
there is not just 1 freeze or (soft) plug, there is about 8 give or take a few
Is there a freeze plug on a 1991 Chevy Caprice?
Yes, several.
Where is the freeze plug at on a 1977 ford pickup?
do I have to drain the water and oil first before I remove the freeze plug
How to change antifreeze in a 2000 Chevy Malibu ls?
Place something beneath the radiator to catch the anti-freeze. Remove the radiator drain plug. Allow the anti-freeze to drain completely out. Replace the drain plug to its original position. Fill the system with new anti-freeze.
Where is the freeze plug on a 91' Chevy beretta gt?
i have a 1994 Chevy beretta and they are under the engine
How do you install an engine block heater 2004 Chevy trail blazer V6-4.2L?
First check and see if there is a pouch located directly beside your battery. If there is a pouch it will contain a plug that is for the factory engine block heater. If there is no plug then you can pursue an aftermarket type. There are several types. If you want to use a freeze plug block heater, you'll need to have someone help you remove a freeze plug. That usually requires that you remove a lot of the peripheral equipment until you can get a clear access to one of the freeze plugs. Measure the freeze plug then go to an auto parts store and purchase a freeze plug block heater of that specific size. Once you have one that will fit into the hole, you can drill a hole in the freeze plug, then use a prying instrument to remove the old freeze plug. The block heater freeze plug usually goes in with a nut to tighten the freeze plug into the hole. BTW, you'll get a lot of antifreeze all over when you do this, and plan on taking your time since it will be time consuming.
