Want this question answered?
In order to remove the headlight switch of a 1988 Cadillac Eldorado, you must first disconnect the negative cable from the battery and allow time for the capacitors to discharge. Unscrew the headlight switch, remove the wire plugs, and remove the switch itself. Insert a new switch and replace the wire plugs and screws. Reconnect the negative cable and test the new switch.
Remove the knobs, remove the dash panel, and replace the switch.
buy a Chevy
it is on the headlight satellite ( stalk) just twist it
there is a pin on the switch which must be depressed to remove the unit from the dash.
Disconnect the negative cable. Remove any screw from the switch. Slide the switch from the dash. Remove the switch and insert the new switch.
Remove the 4or5 screws along the top of the trim plate, the trim plate should pull off,the headlight switch is attached to the trimplate.
puch the knob on the headlight switch in, then turn it clockwise about a quarter inch, then pull it out. Its actually very easy.
It is in the fuse box which is bolted to the headlight switch. You need to remove the headlight switch ti access it.
The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.
check the fuse panel for blown fuse/check headlight switch
Yes. Just switch the headlight brackets out.(remove the headlight bracket from the CRX headlight/ install the CIVIC headlight bracket on the CRX headlight.