First you disconnect the cable from the negative battery terminal. Point the wheels straight ahead. Pry out padded cap carefully, then disconnect the wire to the horn. Remove the nut and washer. Pull steering wheel upward and off. Be careful as you do this.
pull the plastic horn button from the steering wheel by lightly tugging on the four ends. you will see a nut down in the steering wheel. i used a 1 1/16" socket and an extention to remove the nut. unplug the wiring going to the steering column and ignition switch. lightly pull the steering wheel towards you. once the steering wheel is removed you will see the turn signal canceling came, windshield washer switch, and windshield wiper switch. its all one peice. you remover the four screws that hold it down then VERY LIGHTLY pull the whole assembly out. be careful not to brake the plastic housing. once that is out of the way you will see two screws to the right that hold down the ignition switch hold down. remove them the key will have to be in the ignition switch and in the on position. now just lightly tug the switch out. not so bad right? ;) it really is easier than it sounds. just do the reverse to put it all back together. good luck!
this will help you a lot. i forgot about this website
http://www.vw-resource.com/ignition_switch_replacement.HTML
the whole website is a wealth of information.
to remove the ignition switch from a 72 Chevy first remove the steering wheel, then remove the three screws that hold the turn signal assembly the turn signalhandle will unscrew if there is no cruse control if there is the handle will have a screw holding it in place this must be removed under the turn signal assembly there is a screw usually a #27 torx remove this and your ignition switch will slide right out
the dimmer switch is the far left relay on the fuse/relay rack under the front bonnet, pull up and wiggle the relay to remove it
BAD IGN SWITCH
Yes, but you will need to remove any ballast resistor or resistance wire going from the ignition switch to the + side of the coil and replace it with copper.
Front of tranny, kinda sorta on the right side.
Once you remove the dash plastic surround, you will find two bolts that hold the column up into the dash. As you loosen these bolts, the column will drop into your lap. I hope this helps you. Mark
assuming the battery and cables are good and connected....check the ignition switch..:)
look under the dash where the fuse panel is remove the cover (if there is still one there and reach around the very back where the dash is there will be 2 relays there the one to your left closest to the driver-side that's the one you want
The slides are most likely rusted. Remove the 4 nuts per seat from under the car, remove the seats and replace slides
Unhook the battery pull switch out to headlight on position reach under dash to switch , will be a small button on it , push the button at same time pull on switch knob the know and stem will come out use a wide bladed driver and remove the nut that holds the switch in from front of dash unplug wiring remove
location of overflow vent on 1972 VW Beetle IRS rear suspension
In 1972, I bought a 1972 Volkswagen beetle for $1,900.