a plastic wheel cover normally clips on. Use a tire tool or screwdriver to pry around the edges and pop the cover loose from the wheel.
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
Remove the plastic cover directly beneath the steering wheel - two screws on the bottom of the cover.
if its to remove the bat. cover twist than pry out with two flat heads
you need some kind of key or tool to remove it. There is a bolt on either side of the wheel you will see small plastic like doors or covers on the wheel and if it has cruise control remove the cover from that.
behind the driver side wheel. take the wheel off and then remove the plastic cover and the battery is right there just behind the front light.
The mount is located on the drivers side of the vehicle. remove wheel and plastic cover to access.
You first need to loosen the plastic lug nut covers until they are no longer attached to the wheels lug nuts under the cover. After all five plastic lug nut covers are loosened completely from the lug nuts, you can gently pop the cover from the wheel. If the plastic lug nut covers have been damaged so they are not removable, you will need to get some needle nose pliers and basically break off the plastic lug nut covers. (The plastic lug nut covers keep the wheel cover attached to the wheel. The plastic lug nut covers snap into the wheel cover.) And then the game is on----finding replacement plastic lug nut covers and/or wheel covers......speaking from experience!!!
It is held in by a plastic cover underneath the dash just left of steering wheel. Just use a screwdriver and remove the attaching screw It is held in by a plastic cover underneath the dash just left of steering wheel. Just use a screwdriver and remove the attaching screw
Remove left rear wheel plastic housing cover under the body you can then access the antenna motor.
Look in the Owners Manual, they provide instuctions for the parking bulbs. On the front you have to remove a plastic snap holding the plastic wheel well cover (with a flat blade screw driver). Next, pull down the wheel well cover and you will expose the two bulbs. You twist/turn the bulb holder to remove.
if you stand in front of you car it on your left front wheel side you need to remove the front wheel and there is a plastic cover that need to be remove after you remove the cover you will see the filter
To remove rear wheel bearings, first jack the car up so that the rear wheels are off the ground. Then grip the rear tires at 6 and 12 o'clock, and push them in. Finally, remove the transmission tray, engine tray and the plastic cover from the suspension wishbone.