It is not necessary to remove the dash. Only necessary to remove enough of the trim pieces to get the radio out. If you look carefully you will see what needs to be removed.
With the help of a Trim Tool, carefully pry-out the center trim panel from around the radio. Remove the 4 screws, pull out radio, disconnect electrical plug and antenna. Installation is reverse.....
First you take the dash (trim)molding from around the radio then you can get to the four screws that hold it in. All you do then is slide it out. RAy
what are the radio color codes for a2009 chevy impala
I have a 2000 impala and installed an aftermarket radio and amps. First you need to remove the fuse covers on both sides and find the screws that hold the dash in place. the dash will have to be removed in order to access the stero.
how to remove front bumper 2002 Impala
Have it repaired or replace the radio. Either way, you need to remove the whole unit.....
The radio on a 2003 Chevy Impala can be typically be fixed by replacing the fuse. If the radio does not work when powered, it will need to be replaced with a new unit.
you have to take off the front plate of your dash then you need to unscrew the radio. AFter that, you will need to unplug it from its wire harness, then it should just come out.-Shocker
How do i remove a heater core to a 1974 chevy impala?
Impala HQ .com
how d you remove the blender door motor on a 2007 impala
Open driver or passenger door and remove interior panel for fuses. Should be located in the fuse panel
To hook up a radio in a 2001 chevy impala do i need the charm or can it be direct wired
your steering wheel radio controls are bad disconnect and your radio will come on.
Installing a CB radio in a Chevy Impala begins which installing the mount and location a suitable power source. The radio is then mounted to the dash, wired up, and the antenna connected.
Remove the decorative radio cover. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness from the back of the radio.
How do the headrest come an 2010 Chevy impala
Remove the decorative radio cover. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness and the antenna cable from the back of the radio.
i need a step by step instruction on how to remove or replace a radiator of a 2005 3.4L chevy impala
yes! run it to the trunk
Remove the decorative radio retaining plate. Remove the radio retaining screws. Remove the wiring harness, from the back of the radio.