1.Detach the cable from the negative terminal of the battery 2.Clearly label,then disconnect the wires from the terminals on the starter motor and solenoid 3.Remove the mounting bolts and detach the starter
unbolt it and then remove it. Put new one in then tighten it up
follow the positive wire from your battery and it plugs into your seloniod which is connected to your starter.
Remove - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
Remove the negative battery terminal from the battery first, then remove the wires from the back of the starter. Now remove the two bolts holding the starter in and remove the starter. Reverse these steps for installation.
No, absolutely not. All you have to remove is the starter.
Hey Candace==Remove the negative battery cable. Then remove the wires from the starter then the mounting bolts and work it out. GoodluckJoe
Depends. If It Is Stuffed With Cotton, Remove It
14mm
* Detach the negative battery cable * Clearly label then disconect the wires from the terminals on the starter motor and solenoid * Remove the mounting bolts and detach the starter
under the intake manifold. you have to remove all intake hose and intake manifold itself to get to the starter.
where is starter relay on 2006 Honda Accord
follow the pos battery cable to find the starter. Remove the neg cable then the wires to the starter and the mounting bolts and work it out.