Begin by removing the positive cable from your 1998 VW Jetta battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. There will be three starter retaining bolts.
Is this the airplane? Remove one battery post connector. Remove wire connections from starter. Remove mounting bolts. Remove starter. Clean the bolts and starter hole of any dirt or grease. Install new starter with cleaned bolts and reinstall wires and battery connection.
disconnect power from battery, remove wires connected to starter, remove bolts from starter (usually 2), remove starter.
Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
In general, remove negative cable from battery, remove electrical wires from starter, remove bolts holding starter in place, remove starter. Replace starter in reverse order.
Remove - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
where are the two bolts located on the starter?
Disconnect the - battery cable Remove wire at top of starter Remove Starter mounting bolts Remove starter
Disconnect the negativebattery terminal, starter is accessible from under the car passenger side, it bolts into the transmission with 3 bolts. Disconnect the wires from the starter, remove the bolts and reinstall new starter, reconnect wires.
disconnect battery. remove cables at the starter. remove starter mount bolts. remove starter. replace starter. reinstall bolts. reinstall wires. reinstall battery cable.
Locate the starter at the rear of the engine on the passenger's side. Unplug the wiring. Remove the bolts that hold the starter. Remove the starter.
first start by removeing the battery and air cleaner assembly and the you will have access to the starter. then remove the 2 14m bolts that hold in the starter and remove and replaced reinstall all parts and your done.
locate starter, mark and remove wires, remove bolts, remove starter