Want this question answered?
Toyota makes the Tacuma. Chevrolet makes the Tahoe. Which is it?
Hi, Disconnet the battery cables from the battery. Disconnest the battery cable from the back of the Starter motor, and the other red wire., then undo the two bolts holding the starter motor in place one on top and one below the starter motor., withdraw the starter motor from the motor and remove from the car, Installation is the reverse of the dissassembly instructions. Hope this helps
how do i remove the starter motor Mazda rx8
The back side of the motor below the intake and coolant bypass tube
how to remove starter motor on bmw 745
how to remove starter motor for Peugeot 206 1.4 hdi.
How do i remove an Audi A6 Starter motor
disconnect battery. from underneath disconnect solenoid wire and battery cable from starter solenoid. remove starter motor bolts. remove starter motor. installation is the reverse but be sure to place the starter shim between the starter motor and the engine or you will get noise during starts.
To replace the motor you start by removing the exhaust or you can undo the mount and lift out the motor. Consult owners manual for additional information.
# Disconnect the negative battery cable # Remove the air intake duct and the air cleaner assembly # Disconnect the speedometer cable from the transaxle # Unscrew the nut and disconnect the battery cable from the starter motor then disconnect the wiring from the solenoid # Remove the starter motor mounting bolts,supporting the starter motor as the bolts are removed and remove the starter motor
# Disconnect the negative battery cable # Remove the air intake duct and the air cleaner assembly # Disconnect the speedometer cable from the transaxle # Unscrew the nut and disconnect the battery cable from the starter motor then disconnect the wiring from the solenoid # Remove the starter motor mounting bolts,supporting the starter motor as the bolts are removed and remove the starter motor
To remove the starter motor, disconnect the battery first. Take a picture, if possible, so that the new starter can be put back in place the same as the old one was. Disconnect the wires and remove the starter bolts. Remove the starter and replace with a new one. Hook up the wires and the battery.