Want this question answered?
prior out with a flat screw driver
You need to look on the passengers side under the dash..........
If you are attempting to remove the center air vents in the dash panel you will need to: 1. Remove the driver side Cigarette Lighter and the Passenger side Auxiliary plug-in. To do this locate the slot at the bottom on the each of these that will allow you to pop it loose with a screw driver. 2. After removing the panels un plug them and set them aside. You will then see 2 screws, remove these. 3. Carefully pry the panel loose. It will pop off but use gentle force so you do not break the panel. The air vents come off with the panel. From there you can remove them or clean them...
Fuel level, heat or air conditioning up, both high and low, high only, floor only. Center vents are for air conditioning output only, no heat. Heat is designed to blow out side and floor vents only. NOT center. Center is only for air conditioning or summer vents.
You are the most stupid
You can clean the air conditioning by vacuuming out the air conditioning vents. You can also clean the air conditioning condenser vent screen.
no
3
2003 crown vic air conditioning vent dont blow
Sweating occurs when warm air comes into contact with a cold surface. For air conditioning vents it occurs when they are not properly insulated. The ones that do not sweat are either located in a conditioned area or they are properly insulated.
No. While in air conditioning mode, the air will assist in the dehumidification.
It sounds as though the blend door in the heater ducting is stuck open. In a vehicle as new as the Dodge Magnum, this can be fixed by calling the nearest auto parts store for a replacement blend door actuator and replacing it by following the instructions in the package. If no instructions come with the part, you may need to invest in a repair manual which can also been obtained at the part store.