Want this question answered?
Remove bolts on the underside of lid at the hinge. Remove screws on bottom side of the lid. Gently pry bottom of the lid from the top of the lid, there's a metal bracket in between them. The console lid should then be apart from the console.
Pry out the gear selector trim with a screwdriver and lift it out.Open the console lid and remove the screws on the bottom.Remove the screws on both sides of the console.Lift the console up and over the shift lever.Disconnect any electrical connections and remove the console from vehicle.
If you are talking about the arm rest lid, you have to remove the screws at the hinge. If you are talking about the base, it is part of the console and requires more work.
in center console under lid
Unbolt the entire console, something fell down in the front of the front console lid. then turn it over and whatever is jamming it should fall out.
Listed on a placard on the underside of the center console lid.
The lever should be located in the center console between the seats.
Just pull up on the front of the armrest / lid
There is a slot where the pak goes right in the middle of the console (between the power and reset button). You have to carefully remove the lid first in the center to put the pak inside.
if it is loose under the console storage, it is probably the bracket under the storage bin. Remove the two screws holding the lid and the two screws by the latch hole and the two screws on the bottom to remove the inside of the storage area. Once you get it out you might see that the bracket that the screws on the bottom of the storage bin go into is broken. You can get a replacement bracket for about $80.00. You have to remove the console to replace.
Yes, it is all one piece. Remove the rubber bumpers under the lid, remove the screws and compartment liner; remove the 2 screws under the liner; remove the shifter bezel by pulling up; remove the 2 screws that hold the front of the console to the dash; pull up on the emergency brake handle as high as you can, then pull the console back and raise the rear of console and pull up to clear the emergency brake handle.
The center console lid latch may break causing the console lid to pop open frequently. Obtain a 1/4" spring to sit naturally in the latch. this has fixed my latch hook. The issue is the hing is too soft and, when bent, causes the latch alignment pointer to break off. The latch then won't hook properly. Fix has worked for 4 years so far...despite 3 sons.