Want this question answered?
To remove the axle shaft, first remove the wheel, and brake drum/rotor. Second, remove the differental cover. Third, remove the bolt holding the spider gear shaft, and remove that shaft. Fourth push inward on the axle shaft to remove the horseshoe clip on the inside. The axle shaft will now pull out.
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
You have to open the differential and remove the retaining pin from the spider gear to remove the axle shaft.
First off do you want to change an axle shaft or the complete axle housing? for the axle shaft,jack the rear of the truck up take off the wheels and brake drums.make sure truck is securly supported with jackstands.remove the differental cover locate the bolt that holds the cross pin in the carrier.remove the bolt,slide out the cross pin.push the axle in towards the center and remove the c-clip holding the axle in.remove the axle shaft carefully so not to damage the bearings or seal.
I'd need to know if you had a solid front axle or a double wishbone independent front suspension in order to answer this.
how do i remove the axel shaft off the daewoo cielo
Very carefully..
it should come out easily. push the offending axle inward so you can see the retaining clip and remove it. then pull the axle out of the housing. repeat on other side. you have to remove the "spider" shaft first or the axles cannot be pushed inward (it is in the way) Often, the spider shaft is held in with a little screw that has an elongated point or shaft. remove it completely and the spider shaft should slide out. the do the axles.
No, the rear axle shaft does not have an internal retainer clip. You remove the four nuts on the inside of the brake backing plate and remove the axle shaft with a slide hammer and hub adapter.
Remove bolts at center hub Slide axle out Remove spanner nut drums should slide off
Lift bike up off of ground. Remove front brake pads. Remove speedometer gear box screw and pull out cable. Loosen 4 small bolts on axle shaft holder. Loosen axle shaft. Remove axle shaft, 4 small bolts and holder. Wheel will come off.
The car has only one transaxle, AKA transmission, then no, you cannot remove the tranny without removing the tranny. If you mean without removing CV Axle or drive axle or Axle shaft or CV shaft (same thing) then the answer is still no. You cannot remove the transaxle without removing the drive axle/CV shaft.