answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you remove an engine cover on 1988 ford econoline van?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the correct spark plug gap on a 1988 ford econoline 351 engine?

( .044 inch ) according to fordparts.com


Where is the computer on a 1988 ford econoline van e-150 located?

where is the computer on 1988 ford econoline 300 6cyl


Where is the voltage regulator on a 1988 ford econoline 350 460 engine?

I think it is next to the starter solenoid close to the battery.


What is the approximate weight of a 1988 Ford Econoline Van E250?

4607 according to my registration for 6cyl 1988 ford econoline cargo van


Where is the oil filter located on a 1988 Buick Skylark 2.5 engine?

There's a round cover on the bottom of the engine oil pan, you need a special tool to remove it, it's inside that hole.


Where is the fuel pump shut-off switch on a 1988 Ford Econoline 6 cylinder 4.9 engine?

look in the inside of the van in the rear driverside finderwall area you may have to remove the interior in that area to locate it, its a small shiny "box" with a button.


Where is distributor cap on 1988 300sel Mercedes?

Right in front of the valve cover. You have to remove a cover to access it.


How Many 1988 Ford Econoline E350 had a 7.3L Diesel?

20%


Do you have to remove the trans when you replace an engine on a 1988 Nissan Pulsar?

no u do not


Where is the Fuel Shut Off Switch for 1988 Ford econoline Van with 5.8 engine?

right side kick panel just under dash, forword of the door jamb


How do you remove the oil sending unit on a 1988 dodge 3.8 liter engine?

Remove wire and unscrew counterclockwise


How do you replace the water pump seals on a 1988 rm 80?

If it is the seal between the cover and the engine, drain the coolant, remove the hose from the housing on the engine cover, remove the screws/ bolts, scrape the old gasket, dry the area, apply rtv sealant to a new gasket and reassemble. If it is an o-ring leak, remove as specified, install new rings, and reinstall. If the pump is leaking, or the bearing is substantially worn, replace, and reassenble.