You have to remove the interior trim of the lift gate.
To remove and install a door mirror on a 2000 Mitsubishi Mirage, the door panel needs to be removed on the inside of the door. First remove any light lenses in the door, then unfasten the clips holding the door panel on. Then remove the mounting bolt for the mirror. Put in a new mirror, replace the door panel and the light lenses.
how do you change the light bulb over the license plate on 2000 eclipse
if it is the side the battery is on remove it and you will see the light twist and pull it out of its hole replace it then put it back together
DISCONNECT THE NEGATIVE BATTERY CABLE
disconnect the positive connector on the battery
the hazard light flasher relay is bad
the light that look like a carousel and or circus tent is the overflow sensor for the coolant
The light is on because there is a problem. Bring it in and get it looked at. That SRS could save your life someday.
Disconnect battery, if light comes back on you need to get the code read and repair the error.
If you are looking to replace a tag light on your Mitsubishi you will need to remove the old one first. Check you owners manual for instructions on how to do this.
i have a 1994 eclipse with a 1.8 we replaced the head gasket and timeing belt now it sputters at low rpms an the check engine light is on what could be th problem ?
That lights means that your coolant is low.
service engine soon you have a problem with your car that your ECM has detected
on the second generation eclipses it is located at the fulcrum of the arm assembly for the brake pedal.
it resets every time you turn your car on. i have a 01 eclipse and the dealer told me that.
Inside the trunk behind where the brake lights are are a plastic cover. Remove that and you will see one bolt. Reach in to the far side of the light and you will find the second bolt. Remove those and the brake lights can be pulled out. Now just twist the bulb holders and there are your brake light bulbs.
If you want to change the light you have to remove the right rear internal panel (located in the trunk). Only after removing the panel you will gain access to the light. Then it's just matter of removing nuts replacing the light and putting everything together.
You have problems with your air bag system. Try to find a local Mitsubishi Dealer or Autozone garage. They can read out the error message and tell you more.
Remove the shifting console cover. Remove the shifting light retaining ring. Push the light bulb in and turn at the same time. The light bulb will come out. Reverse the process install the new light bulb.
Amber. Which is pretty much orange.
Might Be Yr running out of oil, or water levels are low.
Bad Alternator, Bad Battery, loose cables
there are plastic covers over them on the inside of the trunk that you pop off