Want this question answered?
up to 1995, out the top. 1996-2000, out the bottom.
Push the key into the ignition. To remove, push in, then turn towards you to remove the key. I do not know how to remove and replace the whole ignition assembly in case that was your real question.
You have to remove the trans.
How to remove ignition switch on a 91 Mazda Navajo
The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.
To replace the passenger side mirror on a Chrysler Voyager you need to first remove the window trim. Next, disconnect the wires and unscrew the mirror from the door. Reverse directions to replace with new mirror.
Remove the wiring harness from your 1992 Plymouth Grand Voyager alternator. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
Fuel tank must relieve pressure before you remove it.
dont remove ignition take your vin # to dealer and they can cut a key for less than 10 bucks if it has no chip in it.
The entire ignition switch assembly will unholy from the steering column. The key is required to remove the cylinder from the switch.