raise car and secure with jack stand ,set ebrake.remove wheel.remove three screws that secure plastic on front of wheel well,next remove two nuts that holdthe top of bumper cover.then remove small plastic panel(use screwdriver to pry off)next remove the four nuts that hold headlight assembly.finally remove the wires for the three lights.pull down on bumper cover and remove assy.these will never fall out on their own.small hands are a plus there is not a lot of room.installation is reverse .car now looks new again.old lights had alot of yellowing.
To replace the headlight assembly on a 2006 Jetta, remove the front grill. Then remove the headlight assembly by taking off the screws that secure it in place. Replace with new.Ê
Remove the wiring harness from your 2000 Kia headlight. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.
You have to unbolt the entire soft bumper and remove. The dealer did this on my car to replace the headlight assembly.
The lenses are not removable from the headlights. They are one assembly.
detach the bulbs and remove the clips behind the headlight assembly
it is behind the passenger side headlight assembly. you will have to remove the headlight assembly to replace it.
Open the hood, remove the two locks that hold the headlight assembly in place, with the two locks removed you can wiggle the headlight assembly out and gain access to the back side of the assembly to remove and replace the headlight bulb.
It depends on what vehicle you have, give us more info.
First open the hood and locate the 5mm studs in front of the headlight you wish to replace. Remove the studs and gently pull out the headlight assembly. Remove the headlight assembly by twisting the connectors counter-clockwise. Remove the old bulbs from the assembly and replace with the new bulbs. Reconnect the assembly by attaching the connectors and twisting clockwise. Reinsert the assembly and and attach with the 5mm studs. Close the hood.
the glass cover on the headlight is not servicable, they are glued during assembly. you have to replace the entire headlight globe or headlight assembly.
Remove the wiring harness from the back of your headlight assembly. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.
# Remove the front bumper cover # Remove the upper headlight housing mounting bolt and pushpin # Remove the lower headlight housing mounting bolts # Pull out the headlight housing assembly and disconnect the electrical connector