Dodge Dakota

How do you remove and replace front speakers on 1998 dodge Dakota?

293031

Top Answer
User Avatar
Wiki User
2011-09-13 06:14:41
2011-09-13 06:14:41

if the Dakota doesnt have power windows or locks you need to pop off the window roller, they sell a tool that will make it alot easier but if you don't get the tool you can take a dish wrag and slide it around the window nob until it catches the clip and pops off. then you should be able to lift the door panel right off. a bit hard to explain but make sure you don't lose any of the parts from the window handle

going from last post. there is two t-25 torx bits one in the door handle and the other in the door pull. theres three p2 screws. two at the bottom and one at the mirror cover. remover all 5 in total. than just pull the panel up and out. than disconnect the door latch. the doors ask for a oversized 6 1/2 speaker. use the original spacer to give you more clearance for better speakers.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Which speakers are you trying to replace? Front or rear?

User Avatar

How do I get to the flywheel bolts on a 98 dodge dakota to remove a transmission

User Avatar

You have to remove the fuel tank or truck bed to access it.

User Avatar

A 2003 Dodge Dakota does not have a cabin filter.

User Avatar

You will need to remove the water lines from your 1995 Dodge Dakota truck heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.

User Avatar

link here: http://www.craigcentral.com/durango/speakers.asp

User Avatar

how do you fix transmission on a dodge ddakota

User Avatar

On 2000 Dakota Sport you lower the tailgate and there are 2 Phillips head screws that you remove and the whole tail light module comes out. You can then remove the bulb socket and replace the bulb. On my 2002 Dakota Quad Cab there are 2 torx screws.

User Avatar

What all is involved in replacing a a/c evaporator in a '94 Dodge Dakota?

User Avatar

You have remove panels where the speakers are. And not just any speakers will fit same holes. I bought the Sony Explode the small ones that fit the size from a seller from E-Bay. They are wonderful compare to the factory ones. You can actually hear the voice and sound come out of them. But make sure to get the right size or they won't fit into the hole.

User Avatar

How do you replace a transmission solenoid on a 2001 dodge Dakota 4.7 engine 4x4 location?

User Avatar

You remove the compressor and replace the belt with one for a truck with out ac

User Avatar

Remove rear seat, them remove rear deck to get to the speakers.

User Avatar

6 1/2 inch speakers in both the front and back

User Avatar

Remove the 1992 Dodge Dakota inside door panel. The door handle mechanism will be visible. Remove the door handle linkage. Remove the door handle retaining bolts.

User Avatar

I have 2003 Dodge Dakota Club Cab with overhead console, and need to remove the headliner to have it redone. What is the procedure for removal? Thanks Mick

User Avatar

You have to remove the pan to drain the fluid.

User Avatar

5 1/4 in the front, 5x7 in the back

User Avatar

Metraonline.com, Scosche.com and crutchfield.com are the best places to find out this answer.

User Avatar

remove wheelremove brake caliperremove rotor


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.