Before you begin: DO NOT TOUCH THE NEW BULB WITH YOUR FINGERS!! Open the hood. In the back of the headlight assembly, there is a boot with a wiring harness attached to the back of the assembly. Twist the boot assembly until it pops out (there is a three-pronged tab holding it in). Pull the bulb-in-boot assembly out of the headlight housing. Pull the old headlight bulb out. Plug the new bulb in, referring to the aforementioned warning about not touching it (the oils in your fingers will damage your new bulb). Line the three tabs with the slots in the housing and twist it tight. By the way; Dontcha just love your 89 SEC? There's an SEC club on the internet. Check it out.
remove the screws holding the ring around the light then remove the light.
You can order the part at carpartsdiscount.com installation is easy. Just remove the clamps remove the hose replace the clamps with the new hose.
Yes. Just switch the headlight brackets out.(remove the headlight bracket from the CRX headlight/ install the CIVIC headlight bracket on the CRX headlight.
Wipers on headlights engage when wiper on windshield engages.
replace the light module
1989 Mercedes-Benz 300SEL headlight bulb lamp replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Begin by removing the wiring harness from the back of your 1989 Silverado headlight assembly. Remove the low beam headlight assembly retaining bolts. Reverse the process to install your new low beam headlight.
call a locksmith or order one from dealer
about 1200$ but i can do it cheaper 4235047514
You have to remove the entire door panel. Some models are screwed on and some models just snap on. For the very best advise, take it to you closes Mercedes-Benz dealer. Good luck!
basically just remove the bolts holding it up, disconnect the harness, remove and replace!
See answer I provided for 96 E320. they are the same. Ed Rivera