Parking switch? Do you mean the parking light switch? If you do, The dash will pull loose on the left top and bottom just above the switch and below. From there you can see how the light switch comes out.
You have to remove it gently and go to auto zone and turn it in
how to remove lock cyliner switch 1988 Isuzu pickup
Brute force. Just pull it off.
Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.
Remove cowling from under the steering wheel, remove the two nuts holding the wheel coloum. Drop the steering coloum. Ignition switch is about a foot down on the left side. Unhook the wires remove switch replace. P.S. Unhook battery cables high voltage in ignition system.
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
How do you remove and replace wiper switch on 2002 Chevy Cavalier
First of all disconnect the battery remove steering wheel , there is a round slot in the steering column you insert a rod in there it will release the switch ( be sure to remove negative cable or air bag can go off. You may have to twist the switch back and forth to remove
The best way to replace burned out dash illumination bulbs is to remove the dash cluster. If all the bulbs are not working, check the dash light brightness control to see if that switch is turned off or not working. If you still have parking lights, the fuse is good.
Lower the steering column.
First remove the steering wheel, remove the torx screws and remove the house, remove the signal switch and the wiper switch, remove the torx screws and?æremove the ignition switch. Put in the new switch and replace everything in reverse.?æ
Remove the airbag and steering wheel, remove the torx screws from the steering housing and remove the housing, remove the screws from the signal and wiper switch, and remove the screws above the ignition switch and remove the switch. Replace the switch and replace everything in reverse.Ê